"... does not work in XTC acelerator mode"

Immanuel · Post by **Immanuel** » Sun Jan 18, 2004 12:16 pm

This seams to be a common problem. Is there a common solution?

I tried uninstalling SFP and reinstalling it (apearantly, it didn't delete all my original files, when doing the uninstall). I tried looking in the forum, but didn't find a direct answer - I found people, who have experienced the problem though.

I use Samplitude Classic.

at0m · Post by **at0m** » Sun Jan 18, 2004 8:11 pm

Pulsar1 does not have the 'accellerator mode', this pop-up only shows on first generation cards. It means something like "ASIO can't go below 13ms", that's all.

wayne · Post by **wayne** » Sun Jan 18, 2004 8:47 pm

On 2004-01-18 20:11, at0mic wrote:
Pulsar1 does not have the 'accellerator mode', this pop-up only shows on first generation cards. It means something like "ASIO can't go below 13ms", that's all.

i had always wondered..

thanks at0m

Immanuel · Post by **Immanuel** » Mon Jan 19, 2004 2:40 pm

In my setup is a Pulsar1 and a Scope SRB. The Scope SRB is the first card (on top in the hardware i/o dropdown). Also I tried setting ULLI to the slowest setting. This didn't help.

next to nothing · Post by **next to nothing** » Mon Jan 19, 2004 5:22 pm

On 2004-01-18 20:11, at0mic wrote:
Pulsar1 does not have the 'accellerator mode', this pop-up only shows on first generation cards. It means something like "ASIO can't go below 13ms", that's all.

Not entierly true i guess. I have two luna II cards, and have had the famous message appearing as well. reinstalling did help, and i made sure all devs and .dll's was in the right places. dunno what it was, but it works good now.

arjen · Post by **arjen** » Wed Jan 21, 2004 7:02 am

I noticed this message also appears with a luna II card if you select the wrong asio driver in cubase sx. Select Asio Scope driver to get rid of this message.