Using XTC in Cubase

Nano · Post by **Nano** » Mon Nov 17, 2003 2:21 pm

When using XTC Effect and instruments in Cubase SX1 how do you convert to audio? If I export it just creates a horrible noise. Also how do you create your final mix(Wav File) from Cubase? It would be interesting to see the various methods used.

Thanks
Nano

marcuspocus · Post by **marcuspocus** » Mon Nov 17, 2003 3:12 pm

You route everything to merge output, then create a stereo audio track with Merge input.

You record the mix directly in cubase in realtime

Nano · Post by **Nano** » Mon Nov 17, 2003 5:11 pm

Thanks for the answer. Do you mean I should set the merge output in the master channel on the Cubase mixer. I have looked at the manual and it says I should set the master channel to L merge and R merge, create a new stereo channel and set the input to L merge and R merge.

I have two problems with this. First my mixers master channel only has L merge available for selection. Second I dont have L merge or R merge available for selection in the tracks input section.

My setup is Pulsar XTC, Luna 2, SFP 3.1c and Cubase SX 1.06

Thanks
Nano