Asio drivers wont show up in sequencer?!

SnelleJelle · Post by **SnelleJelle** » Tue Oct 21, 2003 2:15 pm

When I load up asio drivers (source and dest!) in SFP 3.1 and I have restart my sequencer (sonar3.0) my asio drivers don't show up. I use a Pulsar card with a p4 system running XP. It should be there but I think I'm doing something wrong. Anyone?!

Zer · Post by **Zer** » Tue Oct 21, 2003 2:47 pm

Sonar supports Windows soundcards that can use 2 types of drivers: MME and WDM drivers. There is no support for ASIO, EASI or other drivers popular on Cubase and Logic.

so do use wave source and wave dest modules in your project.

SnelleJelle · Post by **SnelleJelle** » Tue Oct 21, 2003 3:25 pm

http://www.cakewalk.com/Products/SONAR/features2.asp

I don't why you think Sonar doesn't Support ASIO because It does support!

siberiansun · Post by **siberiansun** » Tue Oct 21, 2003 5:04 pm

sonar has been using asio drivers since 2.3...

do you use asio2-32 source64 and asio2 dest?
please do so.
did you select "ASIO SCOPE" under options/audio/general
"playback timing master" and
"recording timing master" in sonar?

if you did this and nothing works then i'm lost..

SnelleJelle · Post by **SnelleJelle** » Tue Oct 21, 2003 5:22 pm

Hmm Thanx for your help. Im afraid I did all that! It doesn't work

Post by **garyb** » Tue Oct 21, 2003 7:58 pm

reinstall sfp over the old install.

at0m · Post by **at0m** » Tue Oct 21, 2003 9:26 pm

This usually resets my 'defective' ASIO driver:
Do the ASIO Scope drivers show up on Sonar's driver selection panel? If so, select them while there are no ASIO drivers loaded in SFP project. Then close Sonar, reload the drivers in SFP, and reload Sonar.