Scope Board Seating, PCI Contacts, Installation

Pete · Post by **Pete** » Fri Oct 29, 2004 9:53 am

I had some past issues with my Scope installation or key files suddenly not working, while the board was functional:

http://www.planetz.com/forums/viewtopic ... forum=11&7 for one.

I'm just posting this for information. If your keys don't work, board seating/contact can do that. Tech support gave this advice, which was right, but seemed crazy:

Hello,

please clean all contacts of both boards and try to clean the S/TDM
contacts,too.

now, please uninstall all Scope software and the Scope drivers.

Then, install the drivers from the Scope 4 software first and then the
Scope 4 software.

In my case, putting the board in the end slot apparently let it seat better.

Pete

samplaire · Post by **samplaire** » Fri Oct 29, 2004 11:13 am

Good advice!

Pete, you should have put this thread in the 'tips'n tricks' sub forum, I belive.

_________________

Sir samplaire scopernicus

<font size=-1>[ This Message was edited by: samplaire on 2004-10-29 12:13 ]</font>

Ricardo · Post by **Ricardo** » Sat Oct 30, 2004 9:07 am

Great feedback. And good to know you're a happy Pulsarian again.