I have been using Pulsar 1 for about 2 years. I seem to recall reading a post a long time ago about a way to load VST's into SFP(Pulsar). Is this possible? Or am I just a dreamer?
What I really would like to achieve, is using the Guitar Suite amps by loading them in SFP, in order to achieve no latency. Otherwise the best I can do with my board is 13ms. Which is not that bad, but I would like better.
Any thoughts appreciated.
Thanks, Vaughn
<font size=-1>[ This Message was edited by: NTR Studio's on 2004-09-13 00:51 ]</font>
Is it possible to load VST's in Pulsar? Or am I a dreamer?
You can achieve something similar by use of ASIO. Load an ASIO in/out-module with the amount of outputs you need, or more.
Either run Guitar Rig in self-contained mode or get the application ASIO FX PROCESSOR (or something similar). Set the programs up to whatever ASIO settings needed. Voila, your ASIO modules are now your interface to the world of VST. There will be minimal latency though.
Either run Guitar Rig in self-contained mode or get the application ASIO FX PROCESSOR (or something similar). Set the programs up to whatever ASIO settings needed. Voila, your ASIO modules are now your interface to the world of VST. There will be minimal latency though.