Problem getting Scope to work with Cubase

cleanbluesky · Post by **cleanbluesky** » Sun Aug 08, 2004 11:12 am

Hi

I use a Pulsar II under Win XP with Cubase SX2. I wish to use the GSIF output (which work perfectly when routed to analog dest) into Cubase and record Gigastudio output in Cubase. I cannot however, get Cubase to recognise an ASIO input from the Pulsar, only the analog INs and OUTs.
I start Scope BEFORE Cubase and I setup everything before I open Cubase.
Gigastudio seems to work fine, I think my only problem is getting Cubase to recognise the ASIO..

Thanks
Andrew Valentine

Quifster · Post by **Quifster** » Sun Aug 08, 2004 12:11 pm

in sx 2 you can use the embedded routing table on your vst mixer, here you can add virtual ins and outs to the asio connections of your pulsar. This way you can use all kind of connections in cubase. i have analog ins and outs, DAT channels available through a routing table setup in my default project.

cleanbluesky · Post by **cleanbluesky** » Mon Aug 09, 2004 4:09 am

When I try to add some INs in the VST connections menu it shows only the analog ones...

Quifster · Post by **Quifster** » Mon Aug 09, 2004 4:35 am

did you use the correct asio containers in your scope project?

it sounds like you don't have any asio modules at all in your sfp project.

also use the scope asio drivers in cubase in your device menu.