Pulsar I in XTC mode

[Eurocide]

After two nights of intensive testing I found out the following 'misbehaviours' concerning XTC-mode
of Pulsar I + SRB I on a 700 PIII.

1. the XTC-Delay plug-in doesn't compensate the difference between VST Audio channels and VSTi channels.

1a. several problems with VST/VSTi timing.

1c. Steinberg wrote that they fixed this bug in VST32 R7 PB3. Cannot confirm this.

2. Export Audio of VSTi produces data junk.
The exported WAV sounds like if it was timestreched to 1%.
Tested several export options -> no solution.

3. Did the test with several ASIO driver settings: 16bit - 32 float. 44.1khz and 48khz.

Normal Pulsar mode works fine!
Any ideas?

Borislav,
EC-HQ

[GonZoft]

I confirm 1, 1a and 1c (funny numeration, by the way). As to 2 and 3, set your Cubase master output and mixer inputs to "merge" and do a realtime mix instead of exporting the file.
Cheers.