Combination Luna II and Pulsar 1

fortner · Post by **fortner** » Thu Jul 08, 2004 10:25 am

Hi,
I want to use a Luna II with I/O-expansioncard together with a Pulsar SRB or Pulsar 1. It works, but I can only use the ULLI-settings of the Pulsar 1 down to 13ms.

I remember that I read here about the fact, that if you combine two cards of the first and second generation it would be possible to use the lower ULLI-settimgs of the newer card if you use their I/O's.

(The search-engine of the forum isn`t the best, I didn't find the thread).

How to setup, is it possible to combine these cards as explained?

Bye

Christian

at0m · Post by **at0m** » Thu Jul 08, 2004 10:48 am

When you connect multiple CW DSP boards, one card handles the drivers. It's automatically set nowadays in SFP afaik, but if that fails there's a cset.ini tweak that lets you assign the board order manually. When Luna is set to board0, you can use the better latency of that card.

It's all pretty straight-forward when you install it.

fortner · Post by **fortner** » Thu Jul 08, 2004 10:58 am

Hi atomic,

thanks for ultra-speed-reply, I'll try it!

Bye

Christian