Hi does anybody know if tascams US-2400 controller can be used with a scope/pulsar setup.
I asked this questions to Tascam and Creamware few months ago this is Tacam's response (after 1 day) " the US-2400 is connected via USB 2.0 and will be found as a driverless Standart MIDI Interface.
As communication Protocol with the Software it is using 4x Mackie HUI. So if Scope is able to handle 3 Mackie Huis in parallel it should be no problem to use it."
I am still waiting for Creamwares response.... In the meantime does anybody else know if Scope can handle 3 Mackie HUI's.
Tascam controller surface ok for Scope?
-
marcuspocus
- Posts: 2310
- Joined: Sun Mar 25, 2001 4:00 pm
- Location: Canada/France
Creamware doesn't support mackie or hui at all.
But i use a tascam control surface, the fw-1884, and it is midi programmable, so i can control anything in pulsar, and also in Nuendo.
It support both mackie/hui and standard midi on differents layer. I suspect your only problem to controlling sfp with the us2400 is routing the usb midi port to creamware sequencer src. This is usually done with MIDI-OX pretty easily.
Just make sure before you buy the us2400 (look pretty f...ing nice
) that you can program midi CCs using the control panel.
If not, you won't be able to control sfp with it.
As an option, look at fw-1884, this i can guaranty it's working very very good with sfp, including the motorized fader to control STM1632 or STM2448
But i use a tascam control surface, the fw-1884, and it is midi programmable, so i can control anything in pulsar, and also in Nuendo.
It support both mackie/hui and standard midi on differents layer. I suspect your only problem to controlling sfp with the us2400 is routing the usb midi port to creamware sequencer src. This is usually done with MIDI-OX pretty easily.
Just make sure before you buy the us2400 (look pretty f...ing nice
) that you can program midi CCs using the control panel.If not, you won't be able to control sfp with it.
As an option, look at fw-1884, this i can guaranty it's working very very good with sfp, including the motorized fader to control STM1632 or STM2448