XTC

[icedick]

I', new to this forum... HI
Sorry but I've been looking for this topic for a long time, but cannot find it...

If I want to use pulsar 2 in xtc mode, then every time I start cubase or orion or something, I get the message: "There is another Creamware/XTC application running"
Ain't that a load of shit...

[fidox]

hi,
you should have enabled XTC mode , SFP menu-set-settings and then exit SFP platform, then you can run Cubase

matej

[icedick]

but where can i find the SFP settings? what is it?? ...ScopeFusionPlatform or something like that?

[at0m]

Read manual before use, Ice.

[icedick]

Ive read it manymany times, but in the old days... anyway tanx for helping....
Now I've gotten to a point where i need to enter all my act. keys. But there is no field for entering my Pulsar Propack key, and What about the key for Scope Fusion Platform..? Is'nt it just a "new" update or software for the hardware? Am I supposed to get a new act. key from creamware? .... confused of all the act. keys....

[virtualstudio]

download your all keysfile from "my page" on cw site(old. do the install with option scope,All the devices you get with pro-pack will be automaticly installed.
once you have installed the software, go to settings there you enable xtc-mode

goodluck

edit: sorry only red the last part of your post, when you allready have installed your software, and SFP is asking for your key files something went wrong there!
I would do an uninstall and start over the way I discribe above

<font size=-1>[ This Message was edited by: virtualstudio on 2004-04-06 16:01 ]</font>

[icedick]

Ok Now everything is installed.... going to check it out tomorrow!!!! hopi it is working....
thanx for the help!!

[Kenf]

Hi
Take a look here as well if you are new to XTC mode.
http://www.planetz.com/forums/viewtopic ... forum=3&15
Regards
Kenf