CubaseSX, SFP FX, and no SFP mixers??

dehuszar · Post by **dehuszar** » Mon Feb 09, 2004 11:32 pm

This feels like a really stupid question, but I couldn't find anything in either SFP or Cubase's manuals about this, nor did a search of the Z yield any fruit:

I was just experimenting with mixing in SX and hit a snag. It seems like it should be really straight-forward, but I can't puzzle it out. How does one get an ASIO signal out to an SFP/external effect, and back in to the ASIO dest without using XTC or a SFP mixer (just mixing in Cubase & nothing else). How was it done before XTC?

Or was it?

SX 2.0 only?

SX NOTYET.0?

Sam

dehuszar · Post by **dehuszar** » Mon Feb 09, 2004 11:34 pm

I should mention that I don't want to start eating trackcount bussing the returns into a fresh ASIO channel.

Sam

Kenf · Post by **Kenf** » Tue Feb 10, 2004 5:41 am

How about using XTC mode, I have just mixed using XTC and SX2 and so far works very well... Eq and compressor on most tracks....
Regards
Kenf

dehuszar · Post by **dehuszar** » Tue Feb 10, 2004 12:33 pm

That would mean giving up about half of my favorite and most used plugs... plastic, saturn, etc. ...from my cold dead hands!

Sam

dehuszar · Post by **dehuszar** » Thu Feb 12, 2004 5:40 pm

...so I take it that's a negatory.

Screwed.

Sam

scary808 · Post by **scary808** » Thu Feb 12, 2004 8:04 pm

I may not be understanding what your asking but the only way to run an effect w/o a mixer via ASIO is to connect it in the routing window to the apropriate I/Os.