i have the power pulsar with two ad/da converters. i don't know how to set up in the routing window to get my singal to go out to my monitors to control my volume. i see the monitor fader
i can move them and observe them moving the monitor rotary near the aux sends. but i do not know how to set up in the routing window to get the monitor fader to control my volume externally.how do i connect them in the routing window to control volume extenally to my external gear
please help send email knn9w@aol.com
ken
thank you very much
<font size=-1>[ This Message was edited by: jaukoo on 2003-11-18 12:51 ]</font>
<font size=-1>[ This Message was edited by: jaukoo on 2003-11-18 12:52 ]</font>
external connections
the monitor out of the mixer needs to be connected to the output the monitor amp is connected to(you know,adat dest,zlink dest or analog dest depending on what hardware you used)
if you aren't talking about the headphone monitor for the artists being recorded but you mean your control room monitors,then i would connect the control room output to the appropriate audio destination(once again,depending on whether you connect the monitors to an d/a adat connection or the sp/dif output or the analog output.i use the analog output).
if you aren't talking about the headphone monitor for the artists being recorded but you mean your control room monitors,then i would connect the control room output to the appropriate audio destination(once again,depending on whether you connect the monitors to an d/a adat connection or the sp/dif output or the analog output.i use the analog output).