A16!!!Very Bad!

SMU goes on! · Post by **SMU goes on!** » Thu Feb 22, 2001 5:36 am

I'm using A16 with pulsar I card.Pulsar doesn't work as slave or master at 48kz!WHy?Can work only at 44kz in master mode and A16 in salve mode.I can work at 48kz only if I take the clock from spdif input with pulsar in slave mode and A16 in slave mode.Help me please!!!

My pc : k7 1ghz, soyo motherboard with chipset via,voodoo 4.

Post by **Guest** » Fri Feb 23, 2001 2:02 am

Subject: that's exactly my problem

You can find it just two posts below this one. Could you please complain at creamware support about it !? I just have to do some tests before I complain again.

Martin

Post by **Guest** » Fri Feb 23, 2001 3:07 am

Subject: ?!

well, my pulsar(2) works great with any external gear connected via adatpipe - as master or as slave, at 44.1 and at 48 khz... perhaps you´ve got a defect card?

Mo

Post by **Guest** » Fri Feb 23, 2001 3:25 am

Subject: Solution ?

Are you using an overclocked CPU ?
When I changed my busfrequency back to 100MHZ it worked again well !

Martin

Post by **Guest** » Fri Feb 23, 2001 10:24 am

Subject: I understand...maybe...

Today I tried my pulsar on my pII 400 and it goes all very well!!!I think the problem is my K7 1ghz with its soyo via chipset motherboard!!The bus pci is set to 100mhz but there is incompatibility!!!!On my pII 400 pulsar works as master and slave.The next week I'll change my motherboard and I'll know the truth!!
Bye!