I record my guitar throught a Fostex VC8 and I still got a recognizable latency. I got now 13ms and if i change it 23 it`s getting bigger.
I always thought that routing through ADAT should give no latency at all.
Greetings to all junkies out there who still believe.
I record into logic on PC. I´m just wondering, that I got latency while using the Adat input on Pulsar. I thought that the ADAT Modules are without latency. Maybe I`m wrong and I have to live with 13ms as Pulsar1 does not give smaller lantency.
Yes the converters should only have a few samples of latency.You should dirctly monitor your signal(logic should be able to enable that in ASIO setup).What this does is take the signal from the input of the card straight to the output bypassing the soundcard driver(13ms etc).Or you can setup a project signalling ADAT in to ADAT(or wherever)out.
The Fostex VC-8 has a latency at about 30-40 samples in'n'out...
The 13ms. are from the ASIO driver.
Here's what you do:
1) Use Asio2 24bit source and destination in your SFP project.
2) Disable "Software Monitoring" in Logic's ASIO settings.
Kim!
I`ll tried the ASIO2-24 dest and source.
But after routing them. Only Channel 1+2 are having signal. All the other 30 channels are dead.
(I routed the asio2 1+2 dest to bus 1+2 of mixer (RecordBus) and the 32 Asio2-24 Channels to the mixerinputs)
I don't know about Logic but in Cubase you have to activate bus outputs.1+2 are automatically activated.You then have to set the channels to 3/4 5/6 etc.