This would be a great help

tom · Post by **tom** » Tue Jul 17, 2001 4:56 pm

Luna now works....and i'm too happy for that....now i need to record some parts from my synth in VST5 but it seems that the connection that i've done in the mixer are not ok...

If someone that use VST5+LunaII could send me a project file or a screenshot of his connection that would be really cool..so i can check if i've wrong somethin' or what....

My address is sfavey@yahoo.it
Icq: 102206515

Thanks again...

subhuman · Post by **subhuman** » Tue Jul 17, 2001 5:17 pm

First, load up the ASIO source and destination modules. Then, route audio from Pulsar to the ASIO destination -- once inside the Cubase Mixer, you'll need to "record enable" each channel -- that's it!

To get audio out of Cubase, simply route signals from the ASIO source to your hardware destination like "Luna ANalog Destination."

Post here if you still need something, remember the Manual can be a great help when first starting

tom · Post by **tom** » Tue Jul 17, 2001 6:02 pm

Mhmm....i get the sounds...but..maybe i've to activate some BUS in the VST Master and/or in the VST Mixer?

Check your mail...

Thanks again!

*B*

subhuman · Post by **subhuman** » Wed Jul 18, 2001 7:30 am

Yeah you're close, try using the AUX on the recording mixer connected to ASIO destination, then you can select channel send levels. Alternatively, simply route the Main L&R outputs to ASIO 1&2, and mute everything you DONT want to record (might be easier when first starting)