Pulsar II setting in XP...

SAnd · Post by **SAnd** » Mon Oct 20, 2003 4:11 pm

Hi everybody,
I'm new on XP and I have this question:
In the driver properties the selection of the 24 bit is not possible (also 96 bit), how can I change it? Should I leave this setting as it as?
Thanks in advance

siberiansun · Post by **siberiansun** » Mon Oct 20, 2003 5:14 pm

don't worry 'bout the bit depht in driver settings, just use appropriate asio or wave drivers in SFP.
"24 bit wave source" or "asio2-32 source 64".
samplerate can be set in SFP under "set/samplerate" make sure SFP is set to "master" in the same dialog box.
also you wanna make sure your sequencer is set to "asio scope" in audio driver settings if you're running asio or "creamware play/rec" if you're using wave drivers.

sorry if i over-explained but better safe than sorry

SAnd · Post by **SAnd** » Tue Oct 21, 2003 1:19 am

Thank you siberiansun,
no prob for over-explained...
I'm agree that better safe than sorry

!

Best Regards

SAnd · Post by **SAnd** » Wed Oct 22, 2003 4:37 am

Hello siberiansun,
I download yours Xtc setting, and I would like to thank you... I'll let you know!
I try to control with my Doepfer control the PEQ4 equalizators (or any other devices) in XTC mode. How it works if it's possible? I used to work in SFP, but I would like more simple things in front of my eye !
After mixing I like to edit in Soundforge or Wavelab, how works in XTC? I find something here but... can I have a new step guide for XTC workin way?
My system is on XP, Cubase, Soundforge/Wavelab and Pulsar II.
Thanks in advance

Best regards

SAnd