Question about XTC acceleration mode

enb141 · Post by **enb141** » Thu Jun 19, 2003 12:37 pm

I have a Luna II when I try to use the XTC this message appears to me "XTC can't be loaded in acceleration mode", why appears that message to me?

at0m · Post by **at0m** » Thu Jun 19, 2003 1:11 pm

2 days ago, on another topic:
http://www.planetz.com/forums/viewtopic ... &forum=1&7

enb141 · Post by **enb141** » Thu Jun 19, 2003 1:28 pm

That is for Luna II too?

can I fix it adding a SCOPE SRB?

siberiansun · Post by **siberiansun** » Thu Jun 19, 2003 2:06 pm

nah.. before you open your wallet, try a complete reinstall of SFP.(3.1c)
i ran my luna II in XTC mode without any "accellerator" problems for 6 months before adding a pulsar II.

just remember to backup projects etc before reinstall.

good luck.

enb141 · Post by **enb141** » Thu Jun 19, 2003 3:14 pm

It happened to me twice (I formated my computer and installed again) and I still have the same problem,

The question about SCOPE SRB was because that soundcard has a lot of DSP so I wish to know if that card has that "chip"?