i have just installed a pulsar SRB, for a total of 11 dsp (pulsar1+luna+pulsar SRB)
when i load a lot of things, although i have a lot of free dsp power (in dsp meter window) i sometimes receive a message of dsp error because there are no more stdm connections between board X and Y (where X,Y=0,1,2).
any ideas???
no more stdm connections... ???
-
Music Manic
- Posts: 1743
- Joined: Wed May 15, 2002 4:00 pm
- Contact:
Hello! 
I cant suggest anything. The only thing I can say is that I used to have a Pulsar 1, a Pulsar 2 and a Pulsar XTC and I have never had managed to make the three of them work together without unexpected dsp loads and and no more stdm connections messages and stuff like that! I think for most people, the maximum you can go is with 2 creamware cards in the same PC. With 3, you are likely to encounter problems.
However, try to clean with alcohol the stdm cables and make sure everything is well connected. It can make wonders sometimes!!!
Thank you!
I cant suggest anything. The only thing I can say is that I used to have a Pulsar 1, a Pulsar 2 and a Pulsar XTC and I have never had managed to make the three of them work together without unexpected dsp loads and and no more stdm connections messages and stuff like that! I think for most people, the maximum you can go is with 2 creamware cards in the same PC. With 3, you are likely to encounter problems.
However, try to clean with alcohol the stdm cables and make sure everything is well connected. It can make wonders sometimes!!!
Thank you!
"The one who asks, makes a fool of himself once.
The one who doesnt ask, remains always a fool."
The one who doesnt ask, remains always a fool."
