"xtc plugins..." dialogue box

siberiansun · Post by **siberiansun** » Tue May 13, 2003 5:40 am

Hello dear fellow pulsarians.
I'm getting a bit tired of the "Xtc plugins are not available...." dialogue box that appears everytime i start logic.
i do believe i read somewhere that it's possible to remove it but obviously i don't remember where...

thankful for any help on this, cheers!

mr swim · Post by **mr swim** » Tue May 13, 2003 11:39 am

I think if you go into setup and disable XTC plugins (a little check box) that'll do the trick. I never use XTC myself, and no longer get that little message.

Hope that helps,

Wil.

teejay · Post by **teejay** » Mon May 19, 2003 6:37 am

this message is because you have sfp running when you start the program.
you need to shut down sfp in order to use xtc mode.....

(

siberiansun · Post by **siberiansun** » Mon May 19, 2003 2:47 pm

this message is because you have sfp running when you start the program.
you need to shut down sfp in order to use xtc mode.....(

i'm one inch right now from saying:
"well.......DUH!"
But i won't

Thanks!