XTC plug not properly installed (Cubase Sx)

bluemystic · Post by **bluemystic** » Wed Mar 05, 2003 4:24 pm

Hi,

I'm new in the Creamware world and I bought a PowerPulsar. Everything is ok when I use only SFP for creamware plug-ins. But in XTC mode...

Can someone help me with the following.
The XTC plug-ins are working correctly under Logic 5.5 (PC) but I get the message 'XTC plug not properly installed' as I moved to Cubase SX (PC). More strange, only the Vectron synthesizer and Volkzsampler are available from the VST instruments list.
Even if I refresh the plug-ins via the Plug-Ins Info, they are taken into account.

My SFP project in XTC mode is using ASIO 24bit.

Thx a lot,

Bluemystic

bluemystic · Post by **bluemystic** » Wed Apr 09, 2003 8:35 am

Thanks for your great help...

<font size=-1>[ This Message was edited by: bluemystic on 2003-04-09 09:37 ]</font>

marcuspocus · Post by **marcuspocus** » Wed Apr 09, 2003 9:10 am

Hey, your message must have passed by without notice, i'm sure somebody would have helped you...

I'm sorry i can't, cuz i don't use XTC mode at all.

BUT!

I would suggest reinstalling sfp and tell it to install XTC mode into the new directory for SX...

at0m · Post by **at0m** » Wed Apr 09, 2003 9:49 am

Plus, long install source paths are likely to cause problems. Try installing from for example f:SFP3.1c to for example c:SFP

I don't use XTC to it doesn't work stable enough for me. SFP OS mode is much more reliable on my setup. Good luck