Mixer Automatisation

guitarcat · Post by **guitarcat** » Fri Jan 17, 2003 11:09 am

Hello everybody...big problems here!!!...i wanna use my yamaha 01v to control the stm 2448...i tried everything but nothing happens...can anybody give me a step by step introduction?...that would be realy great...i also tried it with the manuell...but nothing...please...!?...

thanx a lot

guitarcat

paulrmartin · Post by **paulrmartin** » Fri Jan 17, 2003 11:33 am

there is NOTHING in the manual that talks about automation.

I have this Computer Music Magazine article which which talks about using the 01V as a controller. I will dig it out for you.

Stay posted

guitarcat · Post by **guitarcat** » Fri Jan 17, 2003 11:45 am

great man...thank you very much...

paulrmartin · Post by **paulrmartin** » Fri Jan 17, 2003 12:11 pm

Check out this link!

http://www.c-mexx.com/english/5-downloads.htm

C-Console seems to have all that's needed to plug the 01V to anything you might have in your computer. MMC transmit is covered in the sync setup on the Toolbar.

I think I'm going to buy the C-Console!

Be sure to check out the How to tricks in the free downloads. Nice little animation video showing how to control the portamento of a softsynth. If you extrapolate, you can control your 2448 using the same trick.

_________________
Paul R. Martin - Are we listening?

<font size=-1>[ This Message was edited by: paulrmartin on 2003-01-17 12:21 ]</font>