SFP 3.01 Signal Cable doesn't work properly after a reload

raboz · Post by **raboz** » Thu Jan 09, 2003 12:25 pm

Dear All!

I've this big big problem: I create a project with many cables ( midi & signal ) then save it and close SFP.

If I reload it all modules work fine but I need to delete and then re-patch all cables in order for them to carry out the signal ( midi & audio ) ! This is definetly true for mixers ( I've had the problem with Dinamic Mixer and Pulsar 2448 Mixer )

Any Ideas? Am I condamned to become a professional midi&audio cable re-patcher?

Best Regards!

marcuspocus · Post by **marcuspocus** » Thu Jan 09, 2003 2:03 pm

Are you using SFP3.1c ? Cuz, i defenitely don't have this problem... Even my biggest project (using also STM2448) doesn't do that.

raboz · Post by **raboz** » Fri Jan 10, 2003 3:49 am

Dear Marcus,
I don't use SFP3.1c 'cause my system was stable before installing Win XP Professional ( i've also problems with my Akai disks but I've read somewhere in the forum that this should get fixed by a new version of the akai.dll ).

Now I think I'll perform the update.

A question : can I download directly SFP 3.1c or am I supposed to first download SFP 3.1a then 3.1b and then 3.1c?

Thanks in advance for any kind answer!

marcuspocus · Post by **marcuspocus** » Fri Jan 10, 2003 4:33 am

You have to install 3.1a OR 3.1b, then install 3.1c which is an update of either a or b.

raboz · Post by **raboz** » Sat Jan 11, 2003 5:49 am

Thks, You're always very kind!

Best Regards