export problems

emenelton · Post by **emenelton** » Mon Dec 09, 2002 11:35 am

Hello
If anyone can help me, I sure would appreciate it. After trying to put my PulsarII card in a different slot, my project I was working on in Nuendo has 2 problems.
1.certain plugs in the master section no longer process the audio, in fact when they are enabled there is no sound
2. export no longer works, Nuendo seems to go through the export process fine, but the resultant file is only 104kbs.
Any assistance is much appreciated.

Micha · Post by **Micha** » Mon Dec 09, 2002 11:48 am

Usually reinstall of driver helps. Driver is in the unzipped folder under drivers.

Nestor · Post by **Nestor** » Mon Dec 09, 2002 1:55 pm

I can’t be completely sure about it, but this is anyway what I would do if I had the problem: I would do a back-up of the job or jobs you I’m working with, then I would uninstall Nuendo completely, then I would reinstall it and it’s plug-ins, cos it seems a drivers’ route problem. Sometimes reinstalling the drivers may be enough, but if your plug-ins are not working either, I would prefer to start from the beginning. You will very probably solve the problem, I hope so.

emenelton · Post by **emenelton** » Mon Dec 09, 2002 3:30 pm

I did an export non-XTC, and that worked well. How-ever the Master Insert section is still malfunctioning. Do you think that the Pulsar software needs to be re-installed also. I tried changing slots to get rid of pci overload. No slots other than 5 worked.
Win XP sp1 ACPI
Asus P4T533 w/2 sticks 256 non-ecc samsung 32bit RDRAM
this computer is very touchy and doesn't like 3rd party plugs, working at 9624, alot of plugs(vintage warmer, sonic timeworks eq in graphic display mode) send dsp performance meter into overload.