midi integration problem - miditerminal 4140

Nizor · Post by **Nizor** » Thu Nov 14, 2002 4:47 am

hi all, i've just bought a powerpulsar to enhance my studio setup but i have a little problem :
I have a miditerminal 4140 (4 midi in/out) plugged on my parallel port.
How can i use it with SFP 3.1 ???
The software only recognizes the midi i/o from the powerpulsar, but i do not see any modules capable of integrating my interface.
I already looked through the manual, but nothing is mentionned about this.

Can anyone give me a hint about this ??
Thnks a lot.

ps: this site really kicks a...

astroman · Post by **astroman** » Thu Nov 14, 2002 6:07 am

just get the Hubi midi loopback stuff (free on the net)
There's a small app HWMDCABL.EXE acting as a simple patchbay. I use it with a midiman 2 in/4 out. If you start the app there's NO window opening - you have to right click the entry on the task bar and make your settings in the popup.
There are more sophisticated patchbar apps but this is really handy.

cheers, Tom

Nizor · Post by **Nizor** » Thu Nov 14, 2002 7:16 am

thanks a lot.

Too bad creamware did not include a module for this purpose.

That would be cool if some genius scope developper on this forum could come up with a device like hubi's loopback device

marcuspocus · Post by **marcuspocus** » Thu Nov 14, 2002 8:44 am

I recommand strongly MIDI-OX instead of hubi's midi loopback... Lots more flexible, and can be minimized in taskbar... I use it also to redirect my midiman 2x2 to sfp midi ports...

Nizor · Post by **Nizor** » Thu Nov 14, 2002 10:29 am

i've heard of this one on a synth DIY page.

For those of you who want to build your own drehbank (midi controllers), go visit :

http://www.ucapps.de

this is THE site to build your midi controllers to control your whole SFP via hardware knobs