Hello from Newbie & 1st Question

shamanimal · Post by **shamanimal** » Sat Jun 16, 2001 12:18 am

Hello every1 on board

I think about buying a pulsar II or XTC system soon.
So i've been reading a lot topic on several forum here & i must say i'm a bit disapointed.

I'm currently using VST5 with Gstudio on a PIII 600 E & now i'd like to use those Virtual Analog synth around.
All VSTi r CPU hungry.
So i thought Pulsar XTC seems the right choice with their 6 DSP based cards .

Here i need ur knowledge ppl : i'd like to now for each included synth (ezsynth, inferno, FM1, uknow007,BlueSynth, miniscope,VectronPlayer, VolksZampler) how much DSP power is required for 1 voice & or 3 voices.

I also would like to know the same thing about some FX: like the compressor, phaser, 4 pole filter.

I know these Q requires some time to answer but i would really appreciate to have some, as i put more trust in user forums than in a shop salesman

MeloManiac · Post by **MeloManiac** » Sat Jun 16, 2001 2:43 am

Actually they require no time. Just go to the CHARTS section on this page (left frame on the main URL) and click on SYNTHS, I believe it is. There it is.

shamanimal · Post by **shamanimal** » Sun Jun 17, 2001 4:28 am

Thanx a lot MeloManiac !

I didn't see these very important pages