Digital Signal Error

Acid Man · Post by **Acid Man** » Tue Sep 17, 2002 9:18 am

Hi all,

I just bought me some optical cables to connect from my DAT recorder to my Pulsar II card. I can't get this to work so I thought "well I disconnect the cables and change everything back to it's original position". After doing this I keep getting the same message saying:

"Not all the selected devices in the current configuration were succesfully started with their selected options.

If this card is currently configured to accept a digital signal, and no digital signal is present, please either reconfigure the card to use an "internal" clock, or apply a digital signal, or if possible switch this port to accept an analog input."

I know when I still had the optical cables connected to the Pulsar card that I changed this setting in Cubase SX to "slave to SP/DIF". But every time I open up SX I can't switch to the ASIO Scope driver because I get this message every time.

I already tried to create a complete new project in SFP 3.1 but still it gives me this message. Can someone please explain to me what the hell is going on?

Thanks!

Acid

at0m · Post by **at0m** » Tue Sep 17, 2002 9:39 am

Did you set SampleRate back to master in SFP OS? I think you're in XTC mode now.

If it still doesn't work, have you tried feeding clock to the S/P-DIF again from your DAT?

Acid Man · Post by **Acid Man** » Tue Sep 17, 2002 9:49 am

Yep, did all that.

As I explained in my other thread I now do get a signal from the DAT but still it gives me the same error message...

I already re-installed V3.1 and created an entirely new project. But still it says that it's configured to receive a digital signal also when switching back to master in samplerate settings...

?????

Acid