error message...

da poodge · Post by **da poodge** » Sun Sep 08, 2002 11:15 pm

error.
Scope fusion platform is not running or asio source + destination modules are not included in your current project.

Anyone get this? When? My scope platform is running and modules are included in my project.

elektrolurch · Post by **elektrolurch** » Mon Sep 09, 2002 12:35 am

Did you use a registry cleaner before?
This tool eliminates ASIO and Sequencer will not find any ASIO-driver.
This has been described in this forum some weeks ago!

da poodge · Post by **da poodge** » Mon Sep 09, 2002 10:56 am

What can i do about it? Can you point me to the thread on this?

My sequencer is not recognising the asio scope driver. I just upgraded from win 98 to xp.

If anyone can see whats wrong?

da poodge · Post by **da poodge** » Mon Sep 09, 2002 10:59 am

i didn't use regclean so i can not "undo".

at0m · Post by **at0m** » Mon Sep 09, 2002 11:25 am

If you did throw out some of your ASIO stuff from the registry with another cleaner or so, try installing the latest version ASIO sequencer again.