Can't get Cubase to Map to Pulsar midi out??

ontik · Post by **ontik** » Fri Aug 23, 2002 9:39 pm

This is more of a cubase problem, BUT!

Have just installed SFP 3.1a (A little late I know) from Pulsar 3.01a and I'm running Cubase 5.0 r6 (need to upgrade there too!)

I have (in my default project) got my sequencer midi source connected to both my Pulsar II midi dest and Luna II midi dest. In my windows multimedia setup I have 'Creamware Pulsar 1 midi In/Out' selected as my preffered midi device (Same for play and record) and have the 'Use selected devices' check box checked.

My problem is that when I select 'Creamware Pulsar 1 midi In/Out' in Cubase's Midi System settings, close the dialogue then re-open, Cubase defaults back to 'Microsoft GS Wavetable'.

I can't get it to hold my setting!?!? I can select a midi channel and direct it to 'Creamware Pulsar 1 midi In/Out' and send to note data external devices but I need to send midi timing as well to sync it all up and this won't work until I can map midi output in the Midi system setup to 'Creamware Pulsar 1 midi In/Out'?

Anyone else had this?? Any help would be rool kewl!!

virtualstudio · Post by **virtualstudio** » Wed Aug 28, 2002 10:32 am

hi,

start > all programs > steinberg cubase > setup MME > there you can select midi port move up or down for default port.

good luck !!!
Terranova-Amsterdam

ontik · Post by **ontik** » Wed Aug 28, 2002 5:25 pm

Well I've upgraded to 5.1 r1 and this has allowed me to select where the sync is being fired off to. (Couldn't do previously)

But I am looking forward to trying this VS. Thanks heaps.

Cheers.

Nestor · Post by **Nestor** » Thu Aug 29, 2002 11:55 am

I'm working with this newer version of VST and is bettern than before. There is more stability and FINALLY, the box telling me my dongle was badly connected has gone!