MTCtoClock

massusen · Post by **massusen** » Thu May 31, 2001 10:19 pm

Hello,

I´m quite new to the Pulsar and have browsed these forums often- they are a very good resource. However, I haven´t found an answer to this question: the MTCtoClock device, what exactly is it´s output? I was very happy when I saw it- no more MidiClocks out of phase!- but when I send a normal MTC to it, and try to connect it to a Midi-In, the Pulsar just says "cannot make connection, pads are incompatible, and there is no converter available" Hmm? Anyone ?

Massus

John Cooper · Post by **John Cooper** » Mon Jun 04, 2001 9:17 am

I was recently messing with the MTCToClk, trying to use it to convert MTC from my sequencer, out to the syncplate dest, to drive my ADAT. no luck.

when i asked CW about it, they said that this atom is ONLY for use with TDAT (the CW hard disk recording software). i told them that this is different from what it says in the manual, and so, they're changing the manual.

-john

<font size=-1>[ This Message was edited by: John Cooper on 2001-06-04 10:17 ]</font>

massusen · Post by **massusen** » Mon Jun 04, 2001 11:09 am

That´s too bad. It would be very useful for a soundgeek like me to be able to use MTC instead of MidiClock in the Modular.

Thanks for your help.

John Cooper · Post by **John Cooper** » Mon Jun 04, 2001 11:42 am

too bad for me too, as it means that there's no way to drive my ADAT tape from Logic. instead i have to use Scope/SP's VRC and slave both the adat and logic to that. clunky and lame

-john

massusen · Post by **massusen** » Mon Jun 04, 2001 2:30 pm

Is it futile to hope for such a feature in a future upgrade? Maybe if Creamware-staff were monitoring these forums(Maybe they do!), like on the NordModular-list and the Kyma-Forums... There are a lot of things you could wish for... like control-inputs on effects in the Modular... and the possibility to have several knobs assigned to the same controller... and... and

Massus