Hi Everyone!
I need help! It' s a very strange thing: Sometimes when I swicht on my PC and I play a wave the Pulsar play with a noise (like white noise or radio), I move a little its cable and all back Ok. Yes, I know, it could be a problem relating the cables...
Sometimes nothing come out at all (playing a sample or runnig audio sequencer) so I change the samplerate from master to slave and change again from slave to master... and all plays ok again! GRRRRRRRRRRRR! Any idea?
It's cables. And if you push the DSP over the limit or do something that causes an error, you will need to resync the DSPs by toggling master/slave... You also need to do this if you lose your master clock - ie: turn off a SPDIF device that is master, or turn it on after you've started your project, that type of thing.
Also upgrade to SFP 3.1a+ if you aren't running it already.
On 2002-08-19 12:48, subhuman wrote:
It's cables. And if you push the DSP over the limit or do something that causes an error, you will need to resync the DSPs by toggling master/slave... You also need to do this if you lose your master clock - ie: turn off a SPDIF device that is master, or turn it on after you've started your project, that type of thing.
Also upgrade to SFP 3.1a+ if you aren't running it already.
Thanks a lot for your answer!
I solved the problem... I was the cable...
Now it's seems ok. My fear was about the Pulsar II plus (breaked or something else)...
It seems not!!!
GRRRRRRRRRRRR! Any idea?
SAnd