Cubase Monitoring...

fra77x · Post by **fra77x** » Thu May 24, 2001 12:32 am

hi...i'm using cubase to monitor all the pulsar devices - my problem is that when i want to record midi the audio monitor channels record also... is there a way to monitor without "record enable" the channels

thanx

subhuman · Post by **subhuman** » Thu May 24, 2001 8:08 am

Route the ASIO inputs in Pulsar to a Hardware output so you can monitor it

shimi · Post by **shimi** » Fri May 25, 2001 11:06 pm

mute the monitor channels while recording .

electrofux · Post by **electrofux** » Sun May 27, 2001 3:07 am

Try turning off "Multi Record Active" then you just record the track that you have selected in the arrange. The negative side is that then, all the Audio Channels disarm themselves automatically so you have to arm them again in this mode.

electrofux