please help me

lozt · Post by **lozt** » Sun Jun 02, 2002 12:47 am

Can any1 tell me what this means on starting my project this message comes on screen
"pep add routing:pads source switch.in17 and source switch. out are incompatible, cannot route" after I ok this none of my synths work and my system crashs all the time
please help

Spirit · Post by **Spirit** » Sun Jun 02, 2002 1:26 am

Never seen this, but it sounds like an illegal project configuration. Was there something unusual about the routing in this project ? Can you open other projects OK ?

at0m · Post by **at0m** » Sun Jun 02, 2002 2:44 am

seems like you made a loop in your project.

lozt · Post by **lozt** » Thu Jun 06, 2002 2:20 am

I am still having the same problems, does any1 else have any ideas. The problem is with all projects
cheers

wayne · Post by **wayne** » Thu Jun 06, 2002 4:54 am

Unload everything from your project window, save this as startup and default projects in set/settings/projects, then fire it up & see.
Just a thought.

Spirit · Post by **Spirit** » Thu Jun 06, 2002 5:03 am

What was the last project you successfully opened ?

What did you do immediately before this problem ?

Nestor · Post by **Nestor** » Thu Jun 06, 2002 9:25 am

Sorry, never got this one... Never read in the forum about that either...

lozt · Post by **lozt** » Thu Jun 06, 2002 1:37 pm

this is the first time it has ever happened to me, it has happened ever since I loaded up the new 3.1a
has any1 had anything like this???????????????????????????????????

lozt · Post by **lozt** » Thu Jun 06, 2002 1:39 pm

spirit, the last project I was working on successfully was before I upgraded to 3.1a

Spirit · Post by **Spirit** » Thu Jun 06, 2002 7:18 pm

So can you use your system at all ? Can you boot up OK and make new projects, or is this what you get as soon as you open Pulsar ?

Have you tried to reinstall 3.01 ? You could do this, make a simple project then reinstall 3.1 and see what happens.

Do you have any odd devices used in your projects ? Maybe some device that will not work with 3.1 that is causing them problem ? What exactly is in one of these projects ?

Maybe someone else on 3.1 can send you a simple project file with default modules and you can see whether that will load ? (I haven't upgraded).