Weirdest thing..... Sudden change of scooe board priority..

[endre70]

This I dont understand....

I started getting PCI capacity reached messages with my 2 scope cards. I checked samplerate and found that board priorities had changed so that my Luna now was the first board and my Pulsar II my second. I thought something had changed in cset.ini and checked but nooooo.. Nothing had changed and the board priorty command I had previously entered was still there.. When I changed this so board 0=0 and 1=1 Pulsar became the main board again and the pci capacity message stops, as it should.

I dont understand how come the boards suddenly changed priority without cset.ini being changed...

Have anyone got a logical explanation, or is it caused by aliens physically swapping my scope cards?

Endre

[endre70]

And now it happened again after a daw crash... So I needed to change cset.ini again....???.

[dante]

Possibility : **If** board priority stored in project (overriding cset.ini) and then project got corrupted - could explain this affect.

See if you can replicate on a fresh new project.

[Immanuel]

Is Scope open, when you edit cset.ini?

[endre70]

And again today,,,...

Possibility : **If** board priority stored in project (overriding cset.ini) and then project got corrupted - could explain this affect.

See if you can replicate on a fresh new project.

Thanks for the suggestion! I will make a new default project and see where it leads. I will post findings….

Is Scope open, when you edit cset.ini?

No, not to my recollection. But I will make sure it aint from now on.. Thanks!

Endre