Pulsar + Pulsar II + Pullsar XTC Pro

[gigisound]

Hello,
I have a question to ask:
I have two cards pulsar installed on my DAW
(with the cable S-TDM for a total of 10 dsp).
Now I want to install a third card "pulsar xtc pro".
1-I can use a single cable with three connectors S-TDM ?
2-installing the new card "pulsar xtc pro" I could use a total of 16 dsp? (4 +6 +6) ?
3-"xtc pulsar pro" is compatible with s / c scope v5.1 ?

thank you very much for your attention.
gigisound

[jhulk]

yes that is fine for sc5.1

[gigisound]

thank you very much for your reply.

gigisound

[gigisound]

hello,
someone can tell me if it is possible to remove the "classic 20 I / O plate" from the "Pulsar XTC pro" so as to use only the DSP?
It held together to the main board with the plastic rivets.

thank you very much for your availability and expertise
gigisound

[jhulk]

yes it is ok but you will lose the adat ports and midi and spdif and analog i/o

it will then be just a booster 6dsp card

[gigisound]

thank you very much for your reply.

gigisound