Wave drivers at 96kHz problem Solved

[fra77x]

Well, i had problems in win 7 32bit and a Xite, with the wave driver that didin't worked in 96kHz.

How i solved that: In the sound properties at the control panel i selected the "speakers-scope xite-1" (the second with the same name in the list). Now when i clicked properties, it always appeared two tabs, "general" and "levels". But when i clicked right click->test and after that properties then it showed three pads! "general", "levels" and "advanced". So in the advanced pad i selected the 16bit, 96kHz selection and after that i could use the wave source at 96.

Another thing was that the wave destination didn't worked in 96kHz. (even with the previous tip applied).
But i found in reaper that when i select the wdm kernel streaming mode, it works fine! (i use that as an oscilloscope in parallel with wavelab in asio)

That's it

[dawman]

What becomes of the ASIO SOurce and Destination Modules when WDM Kernel streaming is selected..? Can one still use Reaper to host Kontakt and connect ASIO in the project window as I normally do..?