DSP Timeout error

An area for people to discuss Scope related problems, issues, etc.

Moderators: valis, garyb

Post Reply
crowned
Posts: 4
Joined: Fri Jul 12, 2013 3:43 am

DSP Timeout error

Post by crowned »

Hello everyone,

I have a Power Pulsar that fails. I am trying to install it on a windows xp machine with scope 3.1c.
The driver gets installed but after the reboot I get the following error: Hardware cannot be setup properly. System error: timeout waiting for acknowledge from dsp 0.
After this error setup stops. I tried to use another PCI slot but I get the same error.

I have already searched the forum for answers and it seems that the only option would be to send it to Sonic|Core for repairs, but since Creamware is no more that could be quite a problem.
Are there any other options you guys know of to bypass this problem. Is it perhaps possible to use the card as a second card or will it just give the same error?

thanks
-c-
User avatar
garyb
Moderator
Posts: 23378
Joined: Sun Apr 15, 2001 4:00 pm
Location: ghetto by the sea

Re: DSP Timeout error

Post by garyb »

unfortunately, you'll probably just need to replace the card.
crowned
Posts: 4
Joined: Fri Jul 12, 2013 3:43 am

Re: DSP Timeout error

Post by crowned »

That's too bad. Thanks for the info Gary.
Post Reply