Got 2x PulsarII, how to connect via TDM

[emotive]

I looked in the manual but could not find a suitable diagram.

There is 1 x STDM cable with 3x connectors, is this enough?

Thank you for any help offered.

[dante]

Yes. See manual extract here :

http://www.hitfoundry.com/issue_10/stm_mast.htm

[emotive]

Thanks for that info.

I have the 3x connector, so would that be enough and what is the connection, e.g. which actual picture.

(I assume scope professional to scope project is the closest but really have no idea)

[hubird]

you could cut of the cable to the third connector.
The 3 connector cable is for connecting 3 cards

[Mr Arkadin]

One connector is enough, although you could add a second if you want to. It's similar to the third example. You should use the outer two connectors to join the cards and leave the middle one free.

[emotive]

Thanks everyone for responding.

I will try a single cable, however there are 4 edge connectors in total, so which two should I use?

The two that are closest to the "front" of the card, e.g. mounting bracket for the case or the two closest to what I consider there rear of the card towards the inside the machine.

[garyb]

the link dante gave shows this perfectly.