Can't start Xite-1 Scope

[tonatona]

Hi,

yesteday everything worked fine, today i got this error

"A communication error with ScopeXite (brd 0) has occured. This problem ca normally be corrected by reloading the DSPs. Do you want to try that?"

Of course i want. Than i got the error

"Hardware cannot be setup properly:" and "Could not gain access to the SCOPE hardware."


After pc reboot i got this

"Cannot create satellite connection module SAT36xT3A" and some more error messages ending with "Could not gain access to the SCOPE hardware.".


I'm on Win 7 64bit. Nothing was changed since yesteday in my system. Scope software reinstall didn't help.

Any ideas?

[petal]

It might be the cable running from the XITE to your pc that needs to be refixed. Just take it out and put it in again in both ends make sure it's put in properly.

I hope it works

[tonatona]

Thank you petal, it works again.
I tried a second cable before posting but apparently i did something wrong.