Hi to all, I'm just new here,
I have a pulsar1 board and asus a7m motherboard, but often, when I load a modular2 device or other synths, I get the pci capacity limit error.
Could anyone help me resolving this?
This is my setup:
- asus a7m266 bios 1005
- athlon xp 1800
- 512 mb ram 1 stick crucial
- matrox g550 dualhead with 2 LG monitors at 1280 x 1024 16bit colours
- hd ibm primary master + hd maxtor primary slave
- cdreader asus52x secondary master + cdrw plextor4012 secondary slave
- pulsar 1 on pci 3
- running win xp pro in standard mode tweaked for audio
- and no irq sharing
- running pulsar software v3.1
- in asus bios have set pci latency to 128
I think to have done everything I know to resolve this problem, tryed what I found on manual, newsgroups, pulsarlist, but I still have this problem.
Some of you, I've read, has this card and perhaps a similar setup...anyone had a pci capacity problems? Could anyone tell me how to tweak the a7m to the best for pulsar? These error messages are annoying me!!
Thanks to all and bye
D