JD800 Stansalone

[dawman]

I tried this way back when and was told to just have it in the project window, but it doesn;t have a path.
Whenever I use a Sample Oscillator I simply dumo all samples into the Sample Folder and the load buttoin on the Oscillator takes me right there, and I aslo have a significant folder full of vocals, strings, FM1SR EPs FX, hundreds.

What exactly is the JD800 Standalone meant for, and where would I install the Folder...?

Ankyu

[ChrisWerner]

It was meant as an alternative to the modular sample pool, but it is a standalone device. You can handle it like the modular sample pool but load it as a device, just drop it into your project window and open the surface. From there load samples into the pool, save it with all loaded samples, f.e. a vocal pool or a string pool etc. you can drag drop the samples from there to the sample OSCs.

The bad, if I remember right, it doesn't change it's filesize when you remove a sample, so it grows and grows. Something like that.

If you use the pool and build a modular using samples from the pool, you have to load the sample pool device before loading the modular, otherwise the samples aren't found by the sample OSCs.

[dawman]

OK THanks Chief.
But I have always used the Samples folder for all of Bowen synths, or Modular and never had a need for this, but I remember others commenting on they needed it.
Perhaps it's just the JD800 Patch that really needs it....

Anyways Thanks, It's all Good.