Unregistered Device

[MrV]

Hi ,I'm a bit puzzled by an error message .
I recently put together a new PC system based around my old setup Scope 4.5 , 3 PwrPulsars 45 dsp .
Part of my set up was the STW Plate and STW A-100 ...these devices are in my registry and as listed
in the rgy file ,and so on .

However , loading a recent project including STW Plate ...I'm getting "Problem: Unregistered Device"
mentioning the STW ,even though it's there in the project , wired up correctly and can be edited etc ...

What would cause this ?

Thanks , Michael

[YISH313z]

Make sure that you dont have a duplicate anywhere from a previous install, I learned the hard way, I kept getting Masterverb not registered errors because of this, not realizing that Scope was looking in the previous location for the dev.

just my 2 cent

[garyb]

like if you had a v4 folder AND a v5.1 folder?

yes, that would do it...

[MrV]

Thanks chaps , I just realised what happened ... I'd used the larger rgy file of 2 I have , assuming it had all my devices ...
it doesn't ...it covers a range of cards I've had ... the smaller rgy file is actually the correct one and fixed it .
Up there for dancing
Cheers , M