1632

samplaire · Post by **samplaire** » Sat May 18, 2002 2:26 am

1. I don't understand one thing... I work in classic mode (Mac): when I load the module only ins and outs appear with no (or I'm blind) opportunity to see aux/returns connectors. The aux/returns surface doesn't allow to connect anything, the same is in the live bar: only ins/outs. But... after loading one of the presets available (default or test) the aux/returns do appear (in routing window) but don't appear in the live bar.... Strange...
2. Sometimes after disconnecting one channel of a stereo pair the signal doesn't go at all (normally the second channel appears giving sound in one speaker...
3. Sometimes after connecting an input no signal appears in the channel strip window, but does appear in the mix window!!!

borg · Post by **borg** » Sat May 18, 2002 4:08 am

i have to take a closer look for 1,2 and 3, but i'll add a related 4:

MultiFX doesn't seem to pass through midi CC when inserted in an insert slot. (this also goes for all the mixers, i think, except big mixer)

at0m · Post by **at0m** » Sat May 18, 2002 5:03 am

Are you on Mac ok for saving Remote Ctl Presets on this mixer? My SFP autocloses on recall of one of these presets :/

borg · Post by **borg** » Sat May 18, 2002 6:25 am

atomic: haven't tested that.

samplaire: had the same 'thing' with the aux part: they didn't show, until a preset was selected. i hooked up an effect, but had to connect the returns to a mixer channel (i always do that, so no problem) because the return channel on the mixer didn't work here (and that might be a problem to others).

_________________
andy
 the lunatics are in the hall 

[ This Message was edited by: borg on 2002-05-18 07:25 ]

[ This Message was edited by: borg on 2002-05-18 07:26 ]

lore · Post by **lore** » Sat May 18, 2002 6:28 am

Hi sam ,
if u notice when you click on aux on the mixer you'll see the aux send/returns faders, you can notice then that you have a little square space on the top and bottom of the faders (like an insert space) then click with the right button of the mouse on that space and a menu will appear similar to the one of the live bar with all the effects choose one and it connects automatically, you also have an insert on the return fader

very useful !

samplaire · Post by **samplaire** » Sat May 18, 2002 11:06 am

Thanks lore,

I know, I know that. But... as I said before the squares appear only after selecting any of the presets...

[ This Message was edited by: samplaire on 2002-05-18 12:08 ]

lore · Post by **lore** » Sat May 18, 2002 12:55 pm

sorry sam,
i didn't understand ,i thought you couldn't see the send/returns on the module in the "project window" ,cause i can't too, untill i choose an effect on the "device window"

[ This Message was edited by: lore on 2002-05-18 13:55 ]

[ This Message was edited by: lore on 2002-05-18 13:56 ]

samplaire · Post by **samplaire** » Mon May 20, 2002 1:57 pm

On 2002-05-18 06:03, at0mic wrote:
Are you on Mac ok for saving Remote Ctl Presets on this mixer? My SFP autocloses on recall of one of these presets :/

Sorry, I missed your question before.... If you mean MIDI controler in the presets windoew then no problem here...