STM1632 MIXER ALWAYS STARTS MINIMIZED AFTER BOOT

[quantum]

Hi all,

This is not really an issue, but it bothers me a lot. For some reason, the STM 1632 is always minimized after XP finishes booting. I had Pulsar 1 and Pulsar 2 installed before and everything was working smooth. Then I used only Pulsar 2 and uninstalled Scope 4.5 and deleted some registry keys related to scope and am not sure if that's what caused it. But now I reinstalled 4.0 and 4.5 and it just doesn't go back to the old way of start up where the mixer shows up after boot. I tried turning on the "keep on top" buttons but that did nothing. I am thinking it has to do with my projects or personal settings if there are any. I will try deleting my projects and putting back Pulsar 1 with STDM cable, as it was before.

UPDATE: Added Pulsar 1 to Pulsar 2 already inside. No changes. Still no mixer during bootup.

[fidox]

Hi,

So , you want to be your current project maximized while booting into XP ?

I would first, setup a project which i want when booting into XP,
for example , with STM 1632, then in Scope-set-settings-projects-save project as default and save project as startup.
Then, you can also check in Start-run-msconfig-startup if you have "-s" at the end of registry line for Scope startup.

[quantum]

Hi,

Thanks for reply. I solved it by deleting my projects from previous installations, and then shutting down the computer, not restarting it. Then I waited about 10 mins and installed Scope 4.5, loaded all the modules I need, saved that project, restarted and now the STM1632 mixer shows up every time after bootup.

[fidox]

Great