THis has chapped my ass for a long time as I asked if there were charts of the various LFOs, and there aren't I suppose, so then I asked how to change these Patterns using a little more accuracy than the worthless drag and release method.
Again no reply, so I assume that someone here might know of a module or a way to externally change the Patterns through number selection or just an up/down method.
I am game for any suggestions as these LFOs are marvellous but selection is a workflow killer of highest order.
Ankyu.
Pattern LFOs In Flexor III
- next to nothing
- Posts: 2521
- Joined: Mon Jul 29, 2002 4:00 pm
- Location: Bergen, Norway
Re: Pattern LFOs In Flexor III
I am probably misunderstanding you, but if you want to type in numbers in modular you could always do like this.
Of course you could use a bipolar constantval, but then you had to type -64 for lfo type 0 which is confusing![:)](./images/smilies/icon_smile.gif)
Also, for stepping thru with your left or right arrows, just click the waveform once, and step left or right. Ext.patt must be deactivated then ofcourse.
Of course you could use a bipolar constantval, but then you had to type -64 for lfo type 0 which is confusing
![:)](./images/smilies/icon_smile.gif)
Also, for stepping thru with your left or right arrows, just click the waveform once, and step left or right. Ext.patt must be deactivated then ofcourse.
- Attachments
-
- val.png (51.46 KiB) Viewed 2198 times
A positive attitude may not solve all your problems, but it will annoy enough people to make it worth the effort.
Re: Pattern LFOs In Flexor III
I was using the Constant and Ext. but not with the UniPolar conversion Module...........
Ankyu...
Ankyu...
Re: Pattern LFOs In Flexor III
IT woks great but very slow, but accuracy is better than speed in this case.
Why the conversion module though....?
I am assuming it's for a looping/run status versus retriggering...?
Why the conversion module though....?
I am assuming it's for a looping/run status versus retriggering...?
- next to nothing
- Posts: 2521
- Joined: Mon Jul 29, 2002 4:00 pm
- Location: Bergen, Norway
Re: Pattern LFOs In Flexor III
Well the module apparently needs bipolar values to skip through wave 0-127. Using the bipolar constantval-module dierctly just messes my thinking up, since with the unipolar via conversion you can type 2 for wave 2, while with bipolar direct you need to write -62 for the same waveform. So it's just preference ![:)](./images/smilies/icon_smile.gif)
I am not sure what you mean with slow though? Do you have a lag when u enter the value before the waveform is changed?
![:)](./images/smilies/icon_smile.gif)
I am not sure what you mean with slow though? Do you have a lag when u enter the value before the waveform is changed?
- Attachments
-
- val.jpg (25.96 KiB) Viewed 2172 times
A positive attitude may not solve all your problems, but it will annoy enough people to make it worth the effort.
Re: Pattern LFOs In Flexor III
I see.....said the blind man.
Thanx again.
Modular Sundays are such a pleasure...
Thanx again.
Modular Sundays are such a pleasure...