DSP OVERLOAD

CAPO · Post by **CAPO** » Fri May 17, 2002 4:56 pm

Has anyone else had the problem where you load the 1632 mixer (with no other modules loaded) and it tells you that you have a DSP overload and that you should try some global optimization thing. When you do this it still tells you that you have a dsp overload and that "big modules do not fit". When I check my dsp levels in the DSP load monitor device it shows me that I have barely any DSP usage... I am realy confused... would this be a problem with my installation or what? Help!

Spirit · Post by **Spirit** » Fri May 17, 2002 5:02 pm

I've found that sometimes Pulsar seems to "remember" the last big module loaded. A little fiddling - loading and deleting some other little device seems to reset the load.

Does this happen with you all the time or just now and then ?

CAPO · Post by **CAPO** » Fri May 17, 2002 5:15 pm

Every single time I have loaded the 1632 I get this messege. It is realy starting to bug me. I have absolutly nothing else loaded and I load this mixer... then the warning sign shows up. Then, after I close all the windows that pop up, if I click on the module at all, or try to load the analog out for my card it pops the windows up again. even when i delete the module it pops all the warning signs up. AH!

do you have any ideas why this might be happening? I wrote CW to ask and am waiting for a reply. I doubt that they will reply anytime soon but hopefully when they do they will have somthing to say to help.

anyhow, thanks for the reply,

canenero · Post by **canenero** » Sat May 18, 2002 2:38 am

hi.
I had the same problem but using the masterverb in that mixer. I solved loading the old recording mixer from the 3.0.1 (but now i'm back to the 3.0.1 sw so... no more new problem...just the old!!)