I just recieved a used minimax asb yesterday (which I probably overpayed a little for, but thats another story). Played around with it a bit - and loved the sound and especially the feel... I couldn't run the remote software on my Mac, so ran on a PC. Seeing the box was running v. 1.02 i found the 2.0 firmware, saw the keycode in the readme - and the rest is (catastrophic) history... After 20mins of use, my minimax just stands there, blinking at me:
"E1"
I thought that the keycode was generic - and if not, the sw would not be installed, but, alas... After reading this forum, I see that I've made an almost classic error.
I've written support at soniccore with the box's serial, and also 'Ralph' - but no one is responding... (off course, it's summer, so things might have slowed down in Germany.,
). Does anybody here have any ideas at what I can do?? I'm devasted over having jst had 20mins with this very promising baby....
(also, i've figured out a wy to hack the remote software to run with a few glitches on mac osx - but thats another story...)
Crossing fingers for good hints or solutioms....
PopGoblin
