I've changed a cable & then "Hardware version 16 detected"?!

[noise_maker]

Please help me with this

I've change a cable for the microphone, and BAM! creamware gave me some weird Protection messages and since then the program stopped working...

I tried to restart windows and it give me message "installation error - "Hardware version 16 detected".... (it also said hardware ver 30 detected before..)



what to do ?
anyone else suffered from this ?

[noise_maker]

I've fixed it by unpluggin and repluggin the sound card from the motherboard, and when I entered that mic cable I got the annoying protection error again..

shame on you creamware...this protection shit suckz

[Fluxpod]

Soulds like static discharge.Btw.Creamware is dead for years.Everything grounded properly?

[Mr Arkadin]

What's the mic connected to (ie. preamp) before it enters Scope and how does it enter Scope (digitally, RCA jacks, XLR?)?

[noise_maker]

What's the mic connected to (ie. preamp) before it enters Scope and how does it enter Scope (digitally, RCA jacks, XLR?)?

Sound card PL-> XRL Preamp (this one) XLR -> XLRShure58

[Mr Arkadin]

Make sure the phantom powering is off. Do you have the original ART power supply? Make sure it's the right type. As stated above i would check your earthing rather than blame the Scope card straight away.

P.S. The signal flow is actually this:
SM58>Preamp>Scope

As it is a mono preamp do not use a splitter cable.

[noise_maker]

Thank you Arkadin and Fluxpod!