basic problem about midi

[san]

hi ,

I have a problem with my pulsar II midi module .. ( maybe it's me the problem)

I don't succed to pilot my sequencer's with the creamware midi interface .

my routing is : pulsar2 midi A source -------------sequencer midi dest 1

it used to work like this ... but now, no signal received in my sequencer Ableton live 8 ,
In ableton live, creamware midi in out are well reconized and activeted ...

Maybe i'm confused on some points .. i need your help ..

thank you for your help

[Mr Arkadin]

i think you need to activate in Live where it says Output: Creamware MIDI input/output1.

[at0m]

And it might be good to add a Sequencer source module to the routing window.

Actually, you need to load up all Wave and MIDI drivers as set up in Device Manager > Scope > Driver properties. Some apps seem to have issues when the project doesn't contain them all, so throw them in your default project!

[san]

hello !!
thank you for your answers ...

i tried this routing ... and it's ok for midi out, it runs well, i can synchronize my mpc for exemple ..... but still not for midi in




do you have any idea ..

may it comes from scope installation ?

[Mr Arkadin]

Attach a MIDI Monitor to Pulsar2 A MIDI Source and see if there's anything there.

[san]

this is my results with this routing ...

it no seems to be good !!

[Mr Arkadin]

That doesn't look good. What source are you feeding to the hardware MIDI in on Pulsar (ie. keyboard model?).

[san]

i'm using an mpc or midi keyboard !!

[garyb]

ok, so there's some kind of reset message constantly sent from the mpc, what happens when you hit a pad? you should see a note on and note off message(or at least note on). are you sure you have the proper port assigned in the mpc(it has 2 ports, no?)?

[san]

yes the information come from mpc's play button .. but nothing happen when I push a pad ./ the mpc works well because i'm using it with a midi mate usually ( midi-> usb) and i have no problem /

thanks again for your help

[garyb]

if nothing happens when you push a pad, are the pads assigned to the proper output on the mpc?