No polyphony in Modular III

[kronenherz]

Hello.

I am using scope v4.0 and recently had my computer formatted.

Since the latest installation, i have been unable to use polyphony in all Scope devices.

VSTi's used with Cubase 5 and windows internal synthesizer can produce polyphony as usual.

I am a relatively new user and it is possible I haven't configured something as I should have.

Would greatly appreciate any help.

Thaynx

[kronenherz]

I tried raising the "voices" setting in various modular patches, but i can still only produce a single note.

All modules are set to polyphonic mode as well.

[kronenherz]

Played C+G

[t_tangent]

Just on the off chance, as you said that you had recently reinstalled your machine, could it be that when you installed Scope, perhaps not all the files copied across correctly. Also, if you installed Scope straight from the CD, it may be that some of the files still have their Attributes set to read only. There is a batch file utility somewhere in the device section of the forum that might be worth running. It was written by a fellow user, cant remember who off hand, but it has cured many installation troubles for other users in the past, so it might be worth a try, but if not perhaps someone else has some other ideas.

Good luck.

[kronenherz]

Tried it. Didn't work

Thaynx though