V5 IO's

[Jah Servant]

I've noticed that when I open an existing project I get my normal asio2 24bit io but if I remove it it's not available to load again. It's not even in the io folder on the drive. If I load the pro recording example project I get the asio 24bit io but again it doesn't show in the list anywhere. Once you remove it you can't get it back except by loading the project over. If I load the asio 2 source I get an asio2 32 - 64 io. I'm finding this strange, how can the io load when it's in an existing project but yet it doesn't even show in the io's list? Anybody mind checking this out and see if you have the same thing?

[fidox]

yes,
i'm loading projects, which were created in scope 4.5 and i'm using there Asio2 24bit module and yes,
it loads those modules,
but if you check under scope 5 there isn't any.

[Jah Servant]

it is an odd thing, I don't understand how it could happen, how can I have something open that doesn't seem to exist?

[Janni]

Maybe the IO-modules are saved in the project and the driver is still installed? Just a guess...